PVC internal angle for gutter profile 100×110

The installation of the rain gutter system may sometimes require the use of an internal angle when a 90° change of direction is necessary.

View in Interactive catalogue
First Plast gutter systems can be installed according to everyone needs thanks to BI•SYSTEM accessories: this way they can be assembled either with PVC glue or with gasket.

Glue system

Installation with glue is a very easy procedure: first cut gutter profile with a usual hacksaw according to desired length and clean the surface you need to glue with recommended solvent; then apply PVC First-Coll directly from the tube or using a brush; join the two surfaces and allow it to dry.
bi-system-incollaggio
BI•SYSTEM accessories can be also installed with gasket, instead of PVC glue. Adding gaskets to those accessories, they can be easily connected to gutter profiles granting best watertight. Besides, it allows PVC expansions under whatever weather
bi-system-guarnizione
First Plast has been manufacturing PVC gutter channels since 1974. The long experience together with raw material R&D have enabled First Plast to produce gutter systems with excellent resistance to chemicals, physical agents and weather conditions. The certification of conformity to EN 607:2005 specifies that the product meets the requirements for PVC gutters and accessories, intended to be used for drainage of rainwater. Gutter profiles can be marked IIP only after having passed all tests required by the norm. First Plast gutter profiles certified according to EN 607:2005 are models 116, 125, 133 and 100×110.
en-607